The General Information section is where you define the basic setup of your specification. Here, you give your specification a clear name and decide where and when it should be applied.
You can select the categories and products the specification applies to, as well as the inspection points, inspection types, and shipment types it should be used for. This ensures that each specification is applied in the right context, whether it's for incoming goods, shipping inspections, or on-site quality checks.
Here is how you can start setting up your inspection
Name your specification (it is not possible to publish a speciifcation without a name)
Select relevant categories and products from the Products dropdown*
Select relevant inspection points **
Select relevant Inspection types ***
Select relevant Shipment types ****
*If you don’t select any categories or products, then the specification will apply to all categories and products
**If you don’t select any inspection point, then the specification will apply to all inspection points
***If you don’t select any Inspection types, then the specification will apply to all inspection types
****If you don’t select any shipment types, then the specification will apply to all shipment types
